High Performance Microwave components 2Z058 ,  Standard Industrial Products

2.92mm VNA Calibration Kits from Maury Microwave

8770C series, 8770D series, and 8760A series

Features

2.4mm and 2.92mm Connectors DC to 40 GHz

High Performance Phase Matched Adapters

The Importance of VNA Calibration

Any uncalibrated test setup has systematic errors inherent in the equipment used.. The ability to obtain an accurate measurement of a device under test (DUT) depends on how well these errors are corrected.. The basis of network analyzer error correction is the measurement of known electrical standards, such as a thru, open circuit, short circuit, and precision load impedance.. By calibrating your network analyzer with these standards, you can compensate for the inherent imperfections..

Maury 2.92mm VNA Calibration Kits

Maury Microwave’s precision 2..92mm calibration kits are designed for use with a broad range of vector network analyzers (VNAs).. With the components in these kits you can make error-corrected measurements of devices supplied with 2..92mm connectors from DC to 40 GHz..

Each kit is supplied with a set of calibration standards; shorts, opens, sliding and fixed loads (as listed on page 3) and can be ordered with any combination of VNA test set cable connectors..

Calibration Methods Supported

8770C

– Sliding/Fixed Load SOLT (DC–40 GHz)

8770D

– Fixed Load SOLT (DC–40 GHz)

8760A (Tri-Kit)

– TRM/TRL/LRL (DC–40 GHz)

– Fixed Load SOLT (DC–40 GHz)

– Gated Airline

These kits are configured for use in performing one-port SOL (Short-Open-Load) response calibrations (a method used for measuring VSWR/ Return Loss), and full two-port SOLT (Short-Open-Load-Thru) calibration (for performing forward and reverse transmission and reflections measurement).. The Maury TRL/LRL calibration kits are tri-kits containing the components needed to perform three types of calibrations: TRM/TRL/LRL, SOLT, and short-open-(air line + load).. Source match can also be measured using the 15cm air line and provided short circuit..

Connector Description

The precision 2..92mm connectors on the components in this kit are miniature, instrument grade, air-interface connectors that operate mode free up to 40 GHz, and comply with the IEEE

standard 287 general precision connector, instrument grade 2..92.. For detailed interface specifications please refer to Maury data sheet 5E-063..

MAURY MICROWAVE CORPORATION                                      2                                                       TECHNICAL D